See myWAN Faq for more information.
This config asumes that we will be using CLI to identify the incomming call. PPP as the transport protocol. PAP as the authentication protocol, and that calls may be in either direc tion.
Chris's RULE allways use CLI
Collect data to set up link, See Davids PPP Faq for an example form.
Decide on names for isdn call and a number for the ppp interface.
Proceed as for a plain Killostream link and test. When satisfied make the following changes. These are to
NOTE on one of the routers the precidence entery for the ISDN call must b e out and on the other in.
add isdn call={remote router name}
dir=both
inany=off
prec=out
num={remote routers phone neumber}
searchcli=on
show isdn call
set ppp=0 iprequest=off username=local router name}
password={PAP password to send}
set ppp=0 over=syn0 conf=5 lqr=10
add ppp=0 over=isdn-{remote router name} type=secondary
authorization=pap
authmode=in
show ppp=0
show ppp=0 config
Save configs and restart both routers.
create config=backup1.cfg
set config=backup1.cfg
restart router
Check that the routes come backup up and that the link works. Deliberatly fault the leased line link. After a period of 2-3 times the value of the lqr timer the link should come back up over the ISDN, reinstate the kilostream and the PPP circuit should tran sfer back.
These changes should be writen to the logs.
show log
show isdn log